Debugging of plate heat exchanger
by:DIGUANG
2020-07-16
Plate heat exchanger of debugging (
1)
Check and ensure the plate heat exchanger size is correct.
About the size of the information, please refer to the attached drawings.
(
2)
Check and ensure the plate heat exchanger inlet valve has been closed;
If there is a valve outlet, please ensure that the valve is fully open.
(
3)
Open the plate heat exchanger vent, and then start the pump.
(
4)
Slowly open the valve.
(
5)
After all the air out, shut off the plate heat exchanger vent.
(
6)
The cooling water system for plate heat exchanger, repeat steps (
1)
~ (
5)
。
Custom message