Professional heat exchanger manufacturer, plate heat exchanger industry solution expert in China.

Plate heat exchanger frustrated. What should I do

by:DIGUANG     2020-08-09
The plate heat exchanger discouraged about 1. When there is no pressure, according to the size of plate heat exchanger manufacturers provide the clamping to clamping device, the size should be uniform, compact size of deviation should be no greater than & plusmn; 0. 2N ( mm) ( N。 For plate of the total) , the parallelism between the two hold-down plates should be kept within 2 mm. 2. Marking on leakage parts of plate heat exchanger, and then given to solve the break-up of heat exchanger and repackaging or replace the gasket and plate. 3. Will open disintegration of plate heat exchanger, the plate deformation of parts for repair or replacement of plates. Without plate of spare parts can dismantle parts deformation plate temporarily reassembled after use. 4. Reassemble the pieces of plate heat exchanger plate, should clean the board face, prevent dirt adhesion on gasket sealing surface.
Custom message
Chat Online
Chat Online
Chat Online inputting...