Plate Heat exchanger manufacturer, industry solution expert

Plate heat exchanger in some parts of the must be noticed when installation

by:DIGUANG     2020-08-14
Plate heat exchanger in some parts of the must be noticed when installation 1, open the plate heat exchanger after packaging, should according to the packing list item by item check. If do not conform to the requirements, suppliers should be resolved in a timely manner. 2, design of plate heat exchanger improved hole, used for improvement and improvement. Before ascension, please choose according to indicated on the nameplate quality steel wire rope. 3, the plate heat exchanger should be placed, and should be placed where there is no pipe or other equipment jams, so that equipment around about 1 meter of the operating space, easy to maintain. 4, if the plate heat exchanger of the pump outlet pressure is greater than the pressure of the equipment, in the fluid into the equipment, please install a relief valve in the pipeline. 5, if plate heat exchanger to install the pressure control valve, you should install it on the equipment of the feed line, and not installed at the outlet. 6, before installation should clean the plate heat exchanger in and out of the water pipe, prevent sand and gravel, oil pollution, welding debris and other debris into the equipment, so as not to cause internal blockage or damage to the board.
Custom message
Chat Online
Chat Online
Chat Online inputting...